Hardening NXLog Running under a non-root user on Linux NXLog can be configured to improve security by running as a non-root user. The User and Group global directives specify the user and group for the NXLog process to run as. On Linux installations, NXLog is configured by default to run as the nxlog user and nxlog group as shown below. Cisco IOS Cookbook 802.1X Port-Based Authentication Hardening Cisco Routers Cisco Field Security Configuration Guide, Cisco IOS Release 15.2 (2)E (Catalyst 2960-X Switch) Finding The switch must be connected to a Cisco secure Access Control System (ACS) and RADIUS authentication, authorization, and accounting (AAA) must be configured The installation process first copies the operating system files to the hard-disk, reboots, then ask for a few settings and at last install the ACS application (don't worry if you do not have a valid gateway of name server to provide: just give it some random IP address). After the last install round, the ACS will finally restart. To configure remote logging via Cisco ASDM, follow these steps. Connect and log in to the GUI. Go to Configuration > Device Management > Logging > Logging Setup and make sure Enable Logging is selected. In case of a High Availability (HA) pair, Enable logging on the failover standby unit should also be selected. The Link Layer Discovery Protocol (LLDP) is an IEEE protocol similar to CDP. Except that LLDP allows interoperability between Cisco and non-Cisco devices that do not support CDP. Service Config should be disabled unless you're loading configurations from the network. MOP or the Maintenance Operation Protocol is a legacy service used for Here is the configuration below: ! Specify a AAA server name (NY_AAA) and which protocol to use (Radius or TACACS+) ASA (config)# aaa-server NY_AAA protocol tacacs+. ! Designate the Authentication server IP address and the authentication secret key. ASA (config)# aaa-server NY_AAA (inside) host 10.1.1.1. ISBN-10: 1-58720-426-6. ISBN-13: 978-1-58720-426-5. A $199 value, this video and book training package gives you comprehensive coverage of CCNA Security exam topics, providing you with all the assessment, review, and practice tools you need to succeed on the exam. This bundle includes: -LiveLessons DVD with 5 hours of video instruction. Wanted to determine if Anyconnect NAM 4.X (specifically 4.5) is PCI /DSS compatible and what version of TLS will anyconnct support in PCI DSS compliant network. The following features are FIPS-certified on Windows 7 or later, and any exceptions are listed: ACS and ISE do not support Suite B, but FreeRADIUS 2.x with OpenSSL 1.x does. Microsoft Cisco Access Control Server (ACS), Identity Services Engine (ISE), Zero Trust Workplace. Find A Community. Buy or Renew. Find A Community. Close. Cisco Community. English. Chinese; English; ISE 2.3/2.4 Security Hardening Guide? by dlingel on ‎07-05-2018 07:01 AM Latest post on ‎07-06-2018 10:39 AM by hslai. 2 Replies 2072 Views Configuration GuideRouter running Cisco IOS version 15.0M. This guide was tested against Cisco IOS IP Advanced IP Services v15.0.1 as installed by c880data-universalk9-mz.150-1.M4.bin. CIS Cisco IOS 15 Benchmark - New Net Technologies By default, the Cisco Software Checker includes results only for vulnerabilities that have a Critical or ISE 2.0 supports migration from ACS 5.5/5.6. Here is the link for the migration tool guide. Cisco Identity Services Engine, Release 2.0 Migration Tool Guid